Page 508 of 561

AC/OX CUTTING/WELDING/BRAZING Rightward welding

Rightward welding

In rightward welding, the filler rod follows the torch in the direction of the weld. Rightward welding is recommended for the joining of sheet metal and plate of more than 3–4 mm in thickness and for pipe welding. With rightward welding, the risk of tensions in the workpiece is less than in the case of leftward welding.

Rightward welding is used for material thicknesses from 4 mm and up. The filler rod follows the torch in the welding direction.

Horizontal rightward welding Start on the left-hand side of the workpiece and weld from left to right. Move the torch in the direction of weld and feed the filler rod with small rotating movements. The blowpipe must not be moved sideways. It is easier to handle the rod if it is bent as shown in the drawing. See also horizontal leftward welding.

Vertical rightward welding and rightward overhead welding.

Vertical rightward welding This is used for material thicknesses from 4 mm and up.

5.01

The principle is the same as for horizontal rightward welding. 507