Page 448 of 561

PLASMA CUTTING AND GOUGING UNITOR UPC-310 TP Plasma Cutter UPC-310 TP is a lightweight single-phase 110-230V high capacity air plasma cutter. Air is utilized both for plasma gas and for cooling the torch. The plasma process is highly efficient for precision cutting of most electrically conductive materials, and the process is especially suitable for copper alloys, aluminium and stainless steel, which cannot be cut with Acetylene/Oxygen cutting process.

The UPC-310 TP uses a NO HIGH FREQUENCY blowback ignition system. This is of great importance for shipboard use. (Do not interfere with radio communication and other electronically controlled equipment.) Cutting capacity is up to 10mm steel and typical cutting speed is 500mm/ min on 6mm steel.

The output is steplessly adjustable for precision cutting at lower speeds. Compact and Portable, the unit is built on the inverter principle which in addition to excellent cutting properties provides low weight and compact dimensions. The plasma cutter may easily be passed through manholes and brought to any workplace on board.

To protect the operator a micro switch in the torch will cut the current to the torch if the nozzle is loosened. The unit will also shut down if the air supply is insufficient or if the duty cycle is exceeded causing the unit to heat up. Power will automatically be restored when the unit has cooled. The air regulator includes both filter and water separator to protect the torch. Automatic air post flow provides rapid cooling of the torch after cutting.

The UPC-310 TP is equipped with Total Protection (TP), which means that the power supply is monitored and if the voltage should drop below or exceed the tolerance for the unit it will shut down to protect the unit. The unit is also equipped with Flexible Voltage (FV), which means that the machine can be connected to both 230 and 110V without any internal rewiring. * For 110V, higher fuse size is required.

4.04

447