Page 418 of 561

WIRE WELDING

Application set-up for Wire (MIG/MAG) welding

Select Wire welding:

In this mode a constant voltage characteristic for wire welding is set.

Select polarity

Connect the TIG/MIG voltage selection cable to the correct polarity for the selected wire, check information on the label.

Select Wire speed and Voltage

Wire speed is set with the m/min knob on the front panel.

Welding current is set with the VA knob on the front panel, white scale.

2 step wire welding (upper mode) Bring the torch close to the work-piece. Press (step 1) and hold the torch button. The wire advances until it contacts with the work-piece and the arc is lit. Release the button (step 2) to stop welding. The gas flow continues for the selected post-gas time. 4 step wire welding (second mode) Bring the torch close to the work-piece. Press (step 1) and release (step 2) the torch button. The wire advances until it contacts with the work-piece and the arc is lit.

Press (step 3) and release (step 4) the button to stop welding. The gas flow continues for the selected post-gas time.

4.03

-

+

417