Page 329 of 561

RUBBERGRADE 6 REMOULD

3. Application

Using the spatula provided the mixed material should be spread evenly over the prepared area, working the material into any cracks and surface defects. Take care not to trap air bubbles in deep cavities.

4. Machining

Once the RubberGrade 6 ReMould has cured for the minimum time indicated in the Curing Properties

Section of the product specification

sheet, sanding and grinding can be carried out using standard engineering practices.

Hatch cover seals

5. Cleaning

All equipment should be cleaned IMMEDIATELY after each use with a cleaner. Failure to follow this procedure will result in application equipment becoming unusable. 6. Health and safety

3.06

328

As long as normal good practices are observed RubberGrade 6 ReMould can be safely used. A fully detailed Material Safety Data Sheet is included with the set. The information provided in this Instruction sheet is intended as a general guide only. Users should determined the suitability of the product for their own particular purposes by their own tests.

Flanges and mating repairs