Page 317 of 561

CERAMIGRADE LINER

container provided. Mix in the ratio indicated. Lids should be replaced immediately after use. The two components should be thoroughly mixed until completely streak free and a uniform colour is achieved, using the spatula provided. The mixture is initially fluid, but becomes thicker as it sets.

3. Application

Prepared Surfaces should be dry. Using the brush provided the mixed material should be painted evenly onto the prepared area, working the material into any cracks and surface defect. Once the CeramiGrade Liner has reached initial set the material can be separated from surfaces treated with release agent.

procedure will result in application equipment becoming unusable.

6. Health and safety

As long as normal good practices are observed CeramiGrade Liner can be safely used. A fully detailed Material Safety Data Sheet is included with the set. The information provided in this Instruction sheet is intended as a general guide only. Users should determined the suitability of the product for their own particular purposes by their own tests.

When CeramiGrade Liner is used to repair leaking pipes, the flow through the pipe should be discontinued until the repair is made and the CeramiGrade Liner is set. Any leaking fluid must be wiped from the prepared surface before undertaking the repair. When a second coat is required, this should be done as soon as the first coat has set ( within 4 hours ).

3.06

4. Machining

Once the CeramiGrade Liner has cured for the minimum time indicated in the Curing Properties Section of the product specification sheet, sanding, grinding and machining etc. can be carried out using standard engineering practices.

5. Cleaning

All equipment should be cleaned IMMEDIATELY after each use with a cleaner. Failure to follow this

316

General wear on butterfly valve surface