Page 293 of 561

METALGRADE READY-STICK

3. Application

Prepared Surfaces should be dry. The mixed material should be pressed firmly onto the prepared area, working the material into any cracks or surface defects.

When MetalGrade Ready-Stick is used to repair leaking pipes, the flow through the pipe should be discontinued until the repair is made and the MetalGrade Ready-Stick is set. Any leaking fluid must be wiped from the prepared surface before undertaking the repair.

Pipe Joints

4. Machining

Once the MetalGrade Ready-Stick has cured for the minimum time indicated in the Curing Properties

Section of the product specification

sheet, sanding, grinding and machining etc. can be carried out using standard engineering practices. Hole in small diameter pipe

5. Cleaning

3.06

All equipment should be cleaned IMMEDIATELY after each use with a cleaner. Failure to follow this procedure will result in application equipment becoming unusable.

6. Health and safety

As long as normal good practices are observed MetalGrade ReadyStick can be safely used. A fully detailed Material Safety Data Sheet is included with the set.The information provided in this Instruction for use sheet is intended as a general guide only. Users should determined the suitability of the product for their own particular purposes by their own tests.

292

Valve taps