Page 289 of 561

LEAK STOP

3. Application

Remove roll from water and wrap quickly and tightly as follows: Centre tape over leak site, wrap from bottom of roll, pulling firmly throughout application. After 5–7 plies, you will observe resin foam coming through the tape which is desirable and aided by pulling tightly. Continue until entire roll is applied, building to a minimum thickness of 1/2 inch (12 mm) and use a second roll if necessary.

Wrap while pulling firmly

Firmly press and smooth end of roll into wrap in the direction of application. Wet gloves in water, smooth and firmly press the wet resin back into the wrap.

KEEP HANDS MOVING QUICKLY AND WET GLOVES FREQUENTLY TO AVOID STICKING.

Continue rapid hand movement pressing and polishing resin in motions around and parallel to the pipe. Continue process until resins are no longer tacky.

The repair should now have a smooth hard surface and an enamel-like appearance with no fibreglass substance showing throught the resins.

3.06

NOTE: If thicker application is needed spend a little less time finishing the first roll and immediately begin the application of the next. Finish the final roll as if a single roll application.

4. Cleaning

After application dispose of gloves.

5. Health and safety

As long as normal good practices are observed Leak Stop can be safely used.

288

Wet gloves, smooth out

A fully detailed Material Safety Data Sheet is included with the set. The information provided in this instruction for use sheet is intended as a general guide only. Users should determine the suitability of the product for their own particular purposes by their own tests.